Mike (Arizona Wyldwest) Dronelink Expert
Retired. A Hobbyist using the Mavic Air 2, Mavic Mini & Air 3.
Activity overview
Latest activity by Mike (Arizona Wyldwest)
-
Mike (Arizona Wyldwest) commented,
Other then what Jim recommended, Is there a reason why you set the RTH to 1,000’. Depending on your situation I’d set it to 150’ or whatever is needed to stay above all obstacles in that area. It c...
- View comment
- 1 vote
-
Mike (Arizona Wyldwest) commented,
Also Make sure you have gone into the settings on your device and force stopped the DJI App. Otherwise the drone may be trying to connect to the Fly app and the two apps generally cannot be run at ...
- View comment
- 0 votes
-
Mike (Arizona Wyldwest) commented,
https://support.dronelink.com/hc/en-us/articles/360056104694-Why-do-I-see-Unable-to-Take-Control-or-Automatic-Control-Interrupted-during-missions
- View comment
- 0 votes
-
Mike (Arizona Wyldwest) commented,
According to the DL download page only the RC-N2 is supported by DJI. https://www.dronelink.com/download
- View comment
- 0 votes
-
Mike (Arizona Wyldwest) commented,
If you mean rotating the camera to portrait mode then there is already a feature request. I dont think it has been added. https://support.dronelink.com/hc/en-us/community/posts/40309523847827-Mini-...
- View comment
- 0 votes
-
Mike (Arizona Wyldwest) commented,
The firmware is what controls the drones behavior. The RTH state for signal loss disconnect by default in the DJI Fly app is always set to return home. So it more than likely didn’t return at an al...
- View comment
- 0 votes
-
Mike (Arizona Wyldwest) commented,
Check this link. The old Phantom series drones have always worked this way with virtual stick. Have you tried converting to onboard waypoints mission ? https://support.dronelink.com/hc/en-us/commun...
- View comment
- 0 votes
-
Mike (Arizona Wyldwest) commented,
All the default settings in the app are designed to run with all drones without needing to change or add anything. So only the basics like speed, altitude, heading and gimbal are the only things yo...
- View comment
- 0 votes
-
Mike (Arizona Wyldwest) commented,
In regards knowing what functions are supported, you will need to check the DJI specs on each drone to see what the firmware allows. If it can’t be done in the DJI app then it more than likely will...
- View comment
- 0 votes
-
Mike (Arizona Wyldwest) commented,
Yeah the things like gimbal heading and gimbal roll would only work if you have a drone which supports those functions. There are many settings and functions in the app that are specific to a parti...
- View comment
- 0 votes