Learn about support for the Anzu Raptor and Raptor T and how to correctly install the Dronelink Anzu app on the Raptor remote controller. Visit Anzu Robotics to learn more about the drones.
A Professional Growth plan is required for these drones.
Important Notes:
- The Raptor RC must have the Aloft Air Control App version v3.1.6.304 or higher
- There is no iOS support.
- Do not install from the Google Play or Apple App Stores.
What drones are supported?
Supported: Anzu Raptor, Anzu Raptor T
How to install Dronelink on Raptor Remote Controller?
- Visit dronelink.com/download from the Remote Controller Browser
- Select the Anzu Raptor from the list
- Select the Remote Controller image to download the APK and install
- Make sure to Accept ALL permissions during installation
- Force Stop the Air Control App when using Dronelink Anzu. Follow similar steps as seen here to force close an app.
Step-by-step installation instructions are similar to those shown here.
What payloads are supported?
Supported:
- RTK Module - Learn how to setup RTK
Not Supported:
- Loud Speaker
What Mission Types are supported?
Supported: All virtual stick missions (Mapping, Waypoints, Orbits, Facades, Inspection, Panos, Modes, etc)
Not Supported: On-board Waypoints
What thermal features are Supported?
Supported:
- Triggering Thermal Camera
Not Supported:
- Thermal menus, controls and indicators
- Sending thermal camera commands
Configure thermal camera settings in the Air Control App before autonomous flight.
Other Limitations
- Flight logging integrations are not supported (Aloft Air Control coming soon)
- For drone calibrations, use the Air Control app
- Histogram in the flight dashboard is not supported
Updated Mission Planning Camera Specs
New camera specs have been added for the Anzu Raptor and Raptor T
Learn about how to Set Camera Specs During Mission Planning to achieve correct overlaps.