Mavic 3 Enterprise Series (M3E, M3T) Support Overview

  • Updated

Learn about support for the Mavic 3 Enterprise Series, including the M3E and M3T, supported payloads, and how to install the Dronelink app.

A Professional Growth plan is required for this drone.


Important Note: The obstacle avoidance system is not active during Dronelink missions at this time. Dronelink is working with DJI for an update to be released in the future. Take caution and be ready to take control.


What drones are supported?

Supported: Mavic 3E, Mavic 3T (Thermal)

Not Tested / Supported: Mavic 3M (Multispectral)


How to install Dronelink on RC Pro Enterprise?

The Dronelink App must be installed on the Remote Controller by downloading the APK. Do not install from the App Store. More details here.

Visit from the Remote Controller.

Make sure to Force Stop the DJI Pilot 2 App. Learn how here.


What payloads are supported?

Supported: None

Not Supported:

  • RTK Module
  • Loud Speaker

Sign up for updates here to learn when support has been added.


Are there any camera or drone command limitations?

All camera commands that are supported for the M3E that are presented in the camera commands menu are supported. Zoom commands for example, are not listed, and thus not supported.

For thermal commands see section below.


Supported Drone Commands

  • Low Battery Warning Threshold
  • Max Altitude
  • Return to Home Altitude
  • Connection Fail Safe Behavior
  • Home Location
  • Max Distance
  • Max Distance Limitation
  • Serious Low Battery Warning Threshold
  • Smart Return Home
  • Landing Protection
  • Precision Landing
  • Return Home Obstacle Avoidance
  • Upwards Avoidance
  • Vision Assisted Positioning
  • Ocu Sync Channel Selection Mode
  • Ocu Sync Frequency Band

Non-Supported Drone Commands: All other drone commands not listed above.


What Mission Types are supported?

Supported: All virtual stick missions (Mapping, Waypoints, Orbits, Facades, Inspection, Panos, etc)

Not Supported: On-board Waypoints


Sign up for updates here to learn when support has been added.


What thermal features are Supported?


Not Supported: 

  • Thermal menus, controls and indicators
  • Sending thermal camera commands

Configure thermal camera settings in the DJI App before autonomous flight.


Updated Mission Planning Camera Specs

New camera specs have been added for the M3E, M3T.

Learn about how to Set Camera Specs During Mission Planning to achieve correct overlaps.


Was this article helpful?

0 out of 0 found this helpful