Mark Dean

1. Community
2. General Discussion
3. Some clarification on DJI onboard waypoint missions

Have done so - thanks again!

• View comment
• December 30, 2022 00:43
• 0 votes

1. Community
2. General Discussion
3. Some clarification on DJI onboard waypoint missions

Ah - I get it now - yes! I just read the explanation in the link you posted above - which says it all: Multiple Components Dronelink mission plans can effectively run multiple DJI Waypoint missions...

• View comment
• Edited December 29, 2022 23:47
• 0 votes

1. Community
2. General Discussion
3. Some clarification on DJI onboard waypoint missions

Thanks, Jim So just to make sure I'm understanding this correctly - a standard mission (e.g.) with 2 waypoints and 2 orbits, when converted, would result in 4 separate DJI Waypoint missions - the 4...

• View comment
• December 29, 2022 23:27
• 0 votes

1. Community
2. General Discussion
3. Photo Missions

Thanks guys for all your help! For any new photo missions I will use the virtual drone and create photos from the 3D preview screen - it was just converting existing missions that I was looking at ...

• View comment
• December 17, 2022 20:55
• 0 votes

1. Community
2. General Discussion
3. Photo Missions

Thanks, Mike So,  can you alter the position of the drone in the preview window and then have it record the new gimbal position/heading etc. to the photo component itself, or it a case of using the...

• View comment
• December 17, 2022 18:52
• 0 votes

1. Community
2. General Discussion
3. Battery Swap timings in Mission Preview

That's very helpful to be able to add those commands, as I prefer to RTH with 'plenty' of battery power and would never dare risk as low as 15%! There is just so much functionality in Dronelink!

• View comment
• December 16, 2022 23:16
• 0 votes

1. Community
2. General Discussion
3. Battery Swap timings in Mission Preview

I see - so it's more of a guide during the planning stage, rather than a definitive point in the actual mission where an auto RTH is triggered? Thanks Martin and Barry as always for your help

• View comment
• Edited December 16, 2022 23:04
• 0 votes

1. Community
2. General Discussion
3. Add Return to Home command

Just to check - I add the custom message, by adding a title and info to the 'disengage' component itself - then when the mission reaches that point the message displays?

• View comment
• November 27, 2022 13:06
• 0 votes

1. Community
2. General Discussion
3. Add Return to Home command

Oh wow that's excellent - I saw the disengage command and wasn't sure how you'd implement it (still learning). So basically you'd add this command, say, on the completion of a component, then you'd...

• View comment
• November 27, 2022 12:48
• 0 votes

1. Community
2. General Discussion
3. Add Return to Home command

That's a good tip about using the mission preview to plan the battery change points! With my original question still in mind, it now makes far better sense to do things this way, rather than rely t...

• View comment
• November 27, 2022 11:00
• 0 votes