Matthew P CASWELL
Comments
Recent activity by Matthew P CASWELL
-
I'll have to check them out as I have a 3d Printer.. might be fun. I'll post up the results of my test tomorrow morning before it get hot like the surface of the sun here in Arizona. that would b...
- View comment
- 0 votes
-
Thanks, I'll crosspost that link in the Mini FB group because the general consensus that is preached is that it WILL VOID the refresh warranty claims.
- View comment
- 0 votes
-
I'm going to try it with parabolic reflectors installed to direct the signal to the drone and see what happens. I'm not sure if it the drone rejecting the command or if its the controller being una...
- View comment
- Edited
- 0 votes
-
I have a directv dish mounted on the back wall. Wonder if DTV interferes with the signal?
- View comment
- 0 votes
-
So I made a new mission, less complicated and it stops at the exact same spot as the old mission when I fly it over my house at 50'. I went to the neighborhood park and it flew the mission without...
- View comment
- 0 votes
-
Thanks again.. I'll move the whole mission to a neighborhood park and see what happens.
- View comment
- 0 votes
-
Thanks for taking the time to look it over. I'm standing right out front across the street and have line of site for myself and the controller. A similar mission where it goes up to 50 feet and m...
- View comment
- 0 votes
-
I followed and read your comments.. you say you have an S7 and have no issues. If the processor is fast enough do you know what I can do to strip down the resource usage? Is your S7 stock? jim, wha...
- View comment
- Edited
- 0 votes
-
I was able to get it to install on my Samsung Galaxy S7 and even got it to execute a mission.. but 5 seconds in, it quit saying my S7 wasn't fast enough. Matt Caswell
- View comment
- 0 votes
-
I have this same issue and after initial takeoff, it aborts the mission and the drone just sits there. No errors in the mission. Mavic Mini! Disappointing that it doesn't work. Matt
- View comment
- 0 votes