Mark Filip

1. Community
2. General Discussion
3. Start location point vs actual take off point

STarting it the first time.  I shared it with you.  

• View comment
• October 03, 2019 02:46
• 0 votes

1. Community
2. General Discussion
3. Device too slow error and Electromagnetic interference issue

OK, I was hoping that wasn't going to be the case and will have to stick with what I'm currently using. I don't think this would have ended up being a good fit for me due to the fact that it appear...

• View comment
• October 02, 2019 22:50
• 0 votes

1. Community
2. General Discussion
3. Start location point vs actual take off point

sent to your email.

• View comment
• October 02, 2019 22:41
• 0 votes

1. Community
2. General Discussion
3. Device too slow error and Electromagnetic interference issue

My iPad mini 4 is running 12.x but I guess Dronelink is too much for it, and I have minimal apps installed since the only purpose this tablet serves is for flying my Mavic Pro 2.  For now I'm mostl...

• View comment
• October 02, 2019 22:35
• 0 votes

1. Community
2. General Discussion
3. Device too slow error and Electromagnetic interference issue

Hmmm. I'll have to see if Santa will be generous this year.  I guess this answered one of my questions about connectivity in that it appears there needs to be a constant connection for Dronelink to...

• View comment
• October 02, 2019 21:30
• 0 votes

1. Community
2. General Discussion
3. Start location point vs actual take off point

I must not be explaining this right then.  My approach height was 150'.  I took off manually and hovered around 10' and started the mission.  Then the drone flew immediately left about 10' and then...

• View comment
• October 02, 2019 21:27
• 0 votes

1. Community
2. General Discussion
3. Device too slow error and Electromagnetic interference issue

Thanks Jim. I will have to think about both articles, particularly the first article. hmmm, the first link you provided would be bad news for me...I don't want to upgrade to a higher $$ iPad and th...

• View comment
• Edited October 02, 2019 21:19
• 0 votes

Start location point vs actual take off point

I'm new so may not have my terminology right but when I clicked the location to start an approach leg, I could only zoom in so far on the map (online portal). So when I started the mission, I manua...

• Mark Filip
• October 02, 2019 15:25
• 3 followers
• 7 comments
• 0 votes

Device too slow error and Electromagnetic interference issue

Running a short (3 minute) mission on iPad mini 4 and getting a "Device too slow" error, mission was aborted.  I  setup and ran a very similar mission in Litchi and did a free form mission in DJI G...

• Mark Filip
• Edited October 02, 2019 14:46
• 5 followers
• 16 comments
• 0 votes