David White
I am a drone hobbyist and am primarily interested in taking photos and video. My go to app for automation has been Litchi which has served me well. However, while it is great for waypoint missions in general, I wanted more specific control over the drone and camera: enter Dronelink!
Comments
Recent activity by David White
-
Mike, camera commands for the MA2 with the current build are problematic and as Jim mentioned I am waiting on Build 137.If you want to run you current plan in the meanwhile you can add a "Disengage...
- View comment
- Edited
- 0 votes
-
I am curious whether the plan that you successfully ran contained any camera commands other than stop/start, i.e. setting mode, type, etc.?
- View comment
- 0 votes
-
To net this out after several tests, I am unable to set the camera mode or type if it is different from the current setting. If the mode or type settings happen to match, the command list executes ...
- View comment
- 0 votes
-
No, according to DJI Fly, it is set for "single" vs 48mp. I have a similar list for video init I use with my M2P. Likewise it will not run successfully unless I have the UI toggle set for video. A...
- View comment
- 0 votes
-
No. In fact it failed because the interface happened to be toggled to video and it complained about the AEB commands. When I physically toggled the native app interface to photo the same mission w...
- View comment
- 0 votes
-
That would be good news! So, I can assume then with a destination component, I can safely add camera photo commands for execution after the destination has been achieved and the drone is hovering w...
- View comment
- 0 votes
-
Ah, that was the trick I missed. Thank you. Now that works the way I want it to! Another marker question if I may: When I add camera photo commands as part of one of these waypoint markers, what ...
- View comment
- 0 votes
-
So, I fork'd the 360 Pano component into one of my private repositories. There I made a copy and modified it to perform just 1 row/3 frames for a simple 3 shot wide angle pano. I will also play w...
- View comment
- 0 votes
-
Thanks for confirming my thoughts around this. Your response makes more sense. I assume that I can use the 360 component and then modify it, i.e. only do 1 row and/or cut down on the number of col...
- View comment
- 0 votes
-
Just view the 1st post in this forum
- View comment
- -1 votes