a long range mapping mission
Hi
I tried to execute a long range (1.4 Km) mapping mission with a mavic 2 pro. I set the imaging time to photos every 2 seconds.
The drone positioned itself correctly, but when it tried to start the mission itself and had to lower the camera to -65 deg, i got a message that it couldn't activate the camera due to incorrect setting. I entered the menu tab and saw the the camera was set to 10s mode (I didn't set it up this way).
I also noticed that the software alerted me to low reception level. I aborted the mission and tried to control the drone but it would not respond to the sticks, i succeeded to move the camera but the drone refused to move.
Why did the camera mode changed(the 10 s issue)?
Is it impossible to execute mission if i loose communication with the drone(the mission was loaded to it)?
why did the software sisn't respond after I aborted the mission (I only succeeded when i opened the dji GO app, and pressed the rth option)? where is the RTH option in dronelink?
Lior
Comments
5 comments
Please share your mission plan.
These instructions did not work?
Again, please share your mission plan.
Read this: What happens if the drone loses connection?
Hi
the link to my mission is
https://app.dronelink.com/lior-ron-nmuayMuDanYNy2ZLekwf/test1/plan/S3Kn3SaILnQa1dIqek2g/XT6QxIybpEwwcWyNpyw7
where is the rth option through the app?if there is
It appears that the errors you are having are command execution timeouts, which means the drone is at the edge of signal range. There isn't much else you can do about it besides move closing during the mission or get a range extender for your antennas.
You just press the hardware RTH button on the RC.
Hi
It was written in one of your post that you had in your roadmap athought to implement uploading certain types of mission into the drone, have you done that?
No.
Please sign in to leave a comment.