Error launching DJI waypoint file on RC2
The .kmz file I made from Dronelink loaded on the DJI RC2 remote, but a moment after starting the mission, it stated that there was an error launching the waypoint mission and aborted. I haven't dissected the Dronlink generated kml in detail, but I built a utility to generate a test waypoint file and found I got the same error until I noticed that the files generated by the remote had every action ID as unique (not just within the group) and they were allocating every other one integer. I tried this and had success, and I added photo taking events and an initial 1s hover to wait for the gimbal to drop as well. Here is a working waypoint mission file you can as reference:
https://drive.google.com/file/d/1azurELfrSTR9uw9o_Fgy40Q2HRtUl8Qm/view?usp=sharing
Comments
9 comments
Curios if it is a mapping plan. If so can you share the DJI Waypoints converted component plan. I may be able to help once I see it. You should not need to do any extra work.
Yes, had to convert the mapping plan to a waypoint plan, then I exported it for DJI. Here is an example file that gives the error shortly after launching:
https://drive.google.com/file/d/1PrIuRSMNxgjBdZmI0Ma5GqKNoEeuo5dU/view?usp=sharing
Can you share the original dronelink mission?
I believe since it’s a mapping plan it’s due to want was discussed in the link I’m sending. The 0° heading with DJI Waypoints doesn’t interpret the 0° heading As Jim stated. So use either of the two work arounds to get it to load and execute. Simple to fix in seconds and I’ve had no issues. its only when converting a mapping plan with the heading set to 0°. See if this will work for you.
https://support.dronelink.com/hc/en-us/community/posts/44455006607507
Here's the Dronelink share Jim:
https://app.dronelink.com/n8allan/orchard/plan/9AYnZi1ylpeeW1HjTFQB/54O3LcX3AlqJLZLke47c
Could be the 0 deg issue Mike; I haven't tried that work-around yet.
Please try that.
I messed up and sent the wrong link above which discuses the issue. I replaced it above but here it is as well. https://support.dronelink.com/hc/en-us/community/posts/44455006607507
The mapping plan you shared does have the heading to 0°. I imported your plans KMZ into the fly app and it would not load due to the heading which I expected. As I mentioned in the other thread all I do is select any waypoint, click on heading, selected custom, select “Follow Course” and apply to all. Then the mission loads and flys. Enjoy…
Please sign in to leave a comment.