360 HDR with Mavic 3 enterprise

September 30, 2025 14:50
3 comments

I'm trying to capture an HDR 360 pano at 6 set points around a construction site. I've tried to create a pano mission, set the shot type to "AEB" (tried HDR too) but after the second photo is errors saying "please restart the drone/remove this component from the plan. Could anyone help me out?

Comments

3 comments

Mike (Arizona Wyldwest) Dronelink Expert
- September 30, 2025 16:53
Did you create your own Pano or are you using the DL Pano component. Can you share the plan ?

0
Michael Groves
- September 30, 2025 19:19
Hi Mike,

Share link: https://app.dronelink.com/michael-cqazg2huu0df17mwvav7/360hdrtest/plan/zNArkCrkYae7FIxWqGbO/pBNoN6ilrDIKEhRAmOz6

I changed the "HDR" setting to just photo and it worked fine. I'm probably missing something obvious so apologies if its something dumb.

0
Mike (Arizona Wyldwest) Dronelink Expert
- Edited September 30, 2025 19:53
I figured it was due to photo type. The DL Pano was added for connivence and has everything embedded in the component. It is designed to capture a single shot just like the DJI Pano. So most of the camera modes will not work like AEB, Raw, Burst etc... because the time it takes to capture and process is longer than a single photo and may fail. If you want to capture HDR, AEB etc… then check out the public shared Dronelink “360 Photo” component from the public repository. It can be edited and it is possible to add a wait time between captures on each photo to give more time for the longer processing. This will give you much more control of the component which can be edited and set up to meet your needs. If you are knowledgeable enough you can even add rows, columns or different gimbal pitch’s etc. hope that helps. Enjoy.

1