RTH not working as it should
RTH worked at the altitude of the drone at the end of mission, 30ft. Mission was set to RTH and drone setting in djifly was set to 170ft like usual. Looked at log and the tip said "setting new return altitude to 171 ft." before takeoff. Is it necessary to add a command RTH at the end of Mission? I thought that when you config the mission with RTH "action on finish" it would automatically RTH after mission was complete at altitude set in drone unless overridden by DL. It seems like other missions did the same but finished at 150ft or so and I didn't notice the problem. Flying Mavic Air 2 with Ipad 6. Would appreciate any comments. Also can grids be applied to screen like in dJIfly? Thanks
Comments
3 comments
Also interested by the grid on the screen question. I am not able to make it appear.
Yes, this should be the behavior, unless you are within 20m of the home point. In this case we have seen DJI flat out ignore the RTH command or simply land in place. We have no control over this behavior as it is baked into DJI's firmware.
Yes, from the menu button under the wrench icon.
Thanks, been using DL for a couple weeks and the more I learn about it the more I like it. I just learned about Airdata and logs and was wondering if the track airdata produces could be used to analyze the speed of your device based on the little blips in the track?
Please sign in to leave a comment.