MAVIC 3 CLASSIC RC CONTROL waypoints error
I'm trying to test the missions with a mavic 3 classic. I have done all the steps by creating the mission in mission planner, turning it into waypoints and then exporting it. I have followed the step to pass until I get to replace the missions in the waypoints folder. I can see the mission in my control with all the checkpoints. I have a GPS signal. but when starting the mission I generate the following error: ERROR PERFORMING FLIGH. WAYPOINT FLIGHT SUSPENDED. then it doesn't take off and doesn't start the mission. I have tried to do the process 3 times from scratch to check that I have not omitted any step but it continues to show me the same error. What can I do?
Comments
9 comments
Can you share the mission plan?
Jim McAndrew this is the dropbox link with the mission plan. Thanks in advance.
https://www.dropbox.com/scl/fi/n5pj21wmcn6o29oi4gwu1/mapeo-fila-dji-waypoints.kmz?rlkey=tpks7sjoxxjp9wpes0bgnbnx2&st=8l5y9mlg&dl=0
Same problem with Mini 4 Pro + RC2. Any solution to this error?
RC 2 Firmware v07.00.0100
DJI App version 1.18.2
I was never able to retrieve the file, but I suspect it’s too many waypoints.
If it’s not too many waypoints but is a mapping plan then I have a feeling it’s due to the heading issue at 0°. If it is a mapping plan then check the link for assistance. https://support.dronelink.com/hc/en-us/community/posts/44455006607507-Unable-to-load-flight-waypoint
Mini 4 Pro + RC2 : solved adjusting heading to any value different to 0°.
Thanks Mike
This issue has been corrected so this work around is now unnecessary.
👍🏼👍🏼👍🏼
Please sign in to leave a comment.