Camera Start Capture Failed: Command timeout
Hello everybody, this morning I have started using DL for a creation of a simple map. But I was surprised by the error that occurred every time when the drone started up and took 3-4 photos. This is the warning message:
Camera Start Capture Failed: • Please try again by tapping the play button. • If it happens a second time, try restarting the drone. • If it keeps happening, you may need to reorder/remove this component or make it not required. Camera Start Capture | Command timeout
I was not positioned in the center of the area (1,000 m long), but rather at 1/4 of the total distance, but the error occurred at the same way when the drone was at both the near end of the area and the far end. Also, I did not use JPEG+RAW, just JPEG and the interval was automatic (70% overlap in both directions), with the Min. capture interval value being 2 seconds.
Many thanks for your response.
Comments
2 comments
Wrong forum for this - this is the feature request area.
But...once that gets sorted. You need to provide more info. What drone were you using? Did you have obstacle avoidance turned on and, if so, what mode?
Try switching to Time based capture priority, or get closer.
Please sign in to leave a comment.