MA2 Map error.

Edited January 19, 2021 00:44
9 comments

I'm really enjoying using dronelink. I learned a lot from the forums and worked around a couple issues. My latest deals with planning a Map mission. I got the "217" error and found a couple posts about it. I tried setting up a list and issuing the "Camera Photo Type: Interval" and "Camera Photo File Format: JPEG" that I saw mentioned. I did this before the map component. That didn't work. So I tried setting up the same list as an "Immediate" component. Then I got this error:

I don't see any mention of this in the forums so perhaps this is a very obscure error.

Here's my mission:

https://app.dronelink.com/james-p-bankston/holy-angels/plan/Rq45IpbCNcP5QuW4ksGf/raGF2CAB3Lv6TcFdmViv

I'm using an iPhone SE 2020 and Dronelink Version 2.0.1 (136) Kernel Version 2.0.1

James

Comments

9 comments

Jim McAndrew Dronelink Staff
- January 19, 2021 13:22
All the various camera issues with the MA2 on the beta are essentially the same underlying issue, which we are still investigating.

0
Mike (Arizona Wyldwest) Dronelink Expert
- January 20, 2021 16:45
Hi James. As Jim stated they are working in these issues. However, I looked at your mission and there appear to be a few commands missing. You set photo Interval but you didn’t set what the interval amount is. Also no start camera listed. Unless I missed something in Your mission plan you should redo it to something like this.

Photo, JPEG, interval, intervals 4 seconds, Start Capture. You can input how many seconds you want but you must put in the command after the interval command.

Here is a basic photo list command I made. Hope this helps. You may still get errors but they are working on it. Once fully up and running this mission app is great.

https://app.dronelink.com/wyldwestaz/general-photo-intervals/component/N7PEI0Ai4PjXiwlJFAOv/ei003E9TYb5K3IGVQkqq

0
James Bankston
- Edited January 20, 2021 17:14
I assumed that the interval was set in the Map component. There is an entry there so I didn't think setting an interval was necessary. Also, when I looked at the mission in preview mode. there are groupings of "Start capture; a group of photos; Stop capture" so I assumed all that was OK.

0
James Bankston
- January 20, 2021 20:56
I'm afraid I am unable to access the link you supplied in your response. I get an "Unable to view this page" error

0
Mike (Arizona Wyldwest) Dronelink Expert
- Edited January 21, 2021 20:14
try it again James. not sure what happened but it’s worked before. Send a screen shot too.hope this helps.

https://app.dronelink.com/wyldwestaz/general-photo-intervals/component/N7PEI0Ai4PjXiwlJFAOv/gXKXMoCkjqR5Gx9krPQn

0
Jim McAndrew Dronelink Staff
- January 21, 2021 21:52
I just ran James' original mission and it worked without errors on Build 137. Is it working for you now James?

0
James Bankston
- January 21, 2021 21:55
I have build 136. Don't see 137 available in TestFlight.

0
James Bankston
- January 25, 2021 02:17
The mission worked perfectly with build 137. Thanks for the update!

0
Jim McAndrew Dronelink Staff
- January 25, 2021 11:41
👍

0