"Wait" not showing any other components
I was excited to see the 'wait' option available. I wanted to test it out in a controlled environment before adding it to my missions that would make best use of it.
I am flying a Mavic Air.
I created a plan to test a few different wait times - 1 second, 3 seconds, 5 seconds, 10 seconds and 15 seconds. Between each wait it would go to another point a little bit away. I loaded the plan at my take off point, but it showed the total duration as "00:00". Mission Preview said it would be "02:29". Strange. I took off, it hovered 1.2 metres high in front of me and then 'mission accomplished'. No components were actually run at all.
I wondered if it was too complicated with all the different wait intervals, so I changed the mission and removed all the waits. It ran fine. I added one wait option back in and it again hovered in front of me and said mission accomplished without running any components.
Anybody else experienced the issue? I'm really keen to use the wait option in my plans because it will make things a lot easier for me.
Comments
4 comments
The Wait component isn’t supported yet in the App Store version of the app. You need to download the TestFlight version or wait for Apple to approve it for the App Store.
Ah, rightio. Is it possible to get an invite to the TestFlight version? Apple Id is same as email.
Cheers.
https://support.dronelink.com/hc/en-us/articles/360033520874
Perfect. Thank you.
Please sign in to leave a comment.