Scanlink Guyed Towers flight order

I have been flying Guyed Towers using Scanlink, and it has been taking a long time and notice an issue when the software logic applies to a sequence of paths.

1. when the mission starts, it does a down overview of the tower from the top of the tower and then the spiral.

2. then it starts sector 1 capture of the tower from top to bottom

3. then it raises up in altitude to the RAD path 1,2,3

4. then it lowers down in altitude to get the bottom of the tower

Question: Can we change the order of when each line item path is created? Can we tell it that after sector capture do the bottom of the structure overview and then go up to the RAD?

The reason is that it takes the drone time to fly up and down, unnecessary. It also saves battery lifetime.