NTRIP RTK - Setup RTK for M3E - Network RTK
So I read the setup article for the M3E, but my question is - do I even have to set up RTK in Dronelink? Most settings are carried over from the DJI Controller (for example Interval seconds for timed shots come from the controller, but can be overwritten by DL commands).
Is this also true for RTK settings or must I set them up in Dronelink as well?
Comments
8 comments
RTK settings from Pilot 2 will carry over to Dronelink.
Right - Makes sense... Thanks for confirming Barry.
D-RTK settings carry over, but unfortunately not Network RTK - you have to type those in to Dronelink again.
I honestly couldn't remember but a friend was out in the field so I texted him.
He told me it carries over but...I suspect he was using his Emlid for that. I assume an Emlid and a D-RTK would be treated the same?
If Emlid is network RTK then no, they are two separate paths. When you switch between them you have to restart the drone, and when using D-RTK you need to pair it to the base station first in the pilot app. Dronelink will show the connection status but that is all.
OK, but are the NTRIP setting remembered globally in dronelink? So we don't have to reenter them for each project (ever?). I suspect they don't come over from the controller since the RTK parameters are missing from the DJI MSDK. Or is this a Dronelink missing functionality?
If you type them into Dronelink, Dronelink remembers them. They do not come over from Pilot.
Good... Thanks...
Please sign in to leave a comment.