Dronelink max altitude not changing from 49 ft
I am new to using Dronelink and I am trying to do a map mission with dronelink with DJI mini 3. Also normal rc controller. I am using the beta version of the app. I cannot change the max altitude no matter what I do so it never starts the mission. It gets stuck on 49 ft.
Comments
6 comments
I tried opening DJI fly setting the altitude high (it works) then force stopping the app and opening dronelink. But the change is not reflected and I also tried adding a command on the plan.
https://app.dronelink.com/hemanth-kalathil/my-first-project/plan/SyZZrqc9llKPf9GZEG8K/f6zafalQBujtYGR9S5Ww
The plan indicates you have the altitude set at 37m.
Where are you seeing that?
I put the command for 400ft and then also for the map I put 120ft?
Where I see the max altitude being stuck at 49 is on the drone link app. And then when it try’s to run the mission it rises to 49 and says max altitude reached so it never actually starts the mission. Because I have it set to rise to 120ft.
I am sorry I realized where I made my mistake. I mis wrote as meters. I meant feet. I am trying to go to 120 ft and tried setting the max altitude to 400ft but the drone link app is stuck at 49 feet.
Are you a restricted zone / NFZ? When you attempt to set the max altitude in DL does it give an error message?
Ok. Not sure if they still have that beginner mode switch in the DJI Fly app or not. I know at one point it was in there and if I remember correctly the max altitude was 98’ or similar in that beginner mode. Maybe check if it has that enable switch and if so turn if off. If not I had a similar issue about two years ago. I eventually refreshed the firmware on both controller and drone and it fixed the problem. It has never happened since. Can't hurt and doesn’t take long.
Please sign in to leave a comment.