Autorefresh on mission following
We rely a lot on checking that all photos are correctly taken during our mission so we can find a "hole" and fill it fkying by hand before resuming the mission as you can seen on next image. It would be perfect if it could auto-refresh so I am suggesting this as a feature request. Hope it makes sense!
Comments
6 comments
It should already do this (drone every 5s and full data every 60s), assuming the mobile device has a network connection.
Unless I'm mistaken, you are already on the page that shows exactly that.
As an example here is the same screen showing a portion of a mission taken on a very windy day. As you can see some dots are closer together than others.
If you have verify file created turned on also then the drone will stop if a file is not written to the SD card.
Between the two you should have everything you need.
After checking further, the full data does make it to the server every 60s, but the page only loads it once at the start. Will check if it is possible to make it auto referesh like the drone.
This has been fixed and will be included in upcoming updates. The file markers will refresh every 60 seconds. Thanks for bringing this to our attention.
Thanks.
I discovered this feature just this week watching the red dots get out on my mapping mission path on my laptop while flying. Yes it is not quite real time but good enough for now. What I would like to see is a feature that could "recover missing photos" from this display after am mission ends. You have the gaps clearly showing at this point an should be able to add reshoot photos in these gaps, then fly the incremental "recapture gaps" flight. The alternative is to try to create a new sub mapping mission. Very tiring and not accurate as I have experienced.
Please sign in to leave a comment.