Adjusting Mavic 3E Camera Settings for Mapping
Hello,
I used a Mavic 3E to fly a Dronelink mission, and it worked really well. I noticed that it's unclear whether certain critical settings (mechanical shutter, dewarping, and lock gimbal while shooting) are enabled. Therefore, I put in commands that enable mechanical shutter, turn off dewarping, and lock the gimbal while shooting, before the mission starts. I noticed in the mission preview, however, that the gimbal is unlocked prior to moving the camera 90 degrees. Is the gimbal then locked while shooting afterwards? Is there a way of issuing a command to lock the gimbal after the gimbal is positioned 90 degrees for shooting? Any insights would be appreciated!
Best,
Jacob
Comments
3 comments
Dronelink doesn't change these settings unless you add commands to your mission plan, as it seems you have done. You can test if these commands are working by running a command only mission (the drone won't even take off) and then checking if the values were changed in the DJI Pilot UI. If there are specific commands / settings that should be working but aren't please report it here.
Thanks for your response Jim! Just a quick follow up - are you then saying that Dronelink mirrors the settings in the DJI Pilot 2 app?
Most of the settings in the apps are actually just setting the values in the drone’s firmware, which means they carry over between all apps.
Please sign in to leave a comment.