Mavic Air 2: Mission aborted due to "Camera Focus Mode "Auto"
Hello,
I was executing a hyper lapse mission with the Mavic Air 2 and it failed with the error listed below. Is Camera Focus mode Auto supported on the Mavic Air 2 ? The other options are "Continuous Focus" and "Manual". This is one of the steps in the Camera Reset Setting from the DroneLink repository.
Camera Focus Mode Failed: • Please try again by tapping the play button. • If it happens a second time, try restarting the drone. • If it keeps happening, you may need to reorder/remove this component or make it not required. Camera Focus Mode | Auto | -1013
Comments
4 comments
You need to remove the command or mark it as not required.
That did it, the hyper lapse was successful for the most part except for 2 things:
1. Mission ended a few seconds early stating the battery was at 20%, but I know I had at least 40%. I removed the battery warning task from the drone reset list. Looks like the 20% is off for a Mavic Air 2.
2. The plan was a corkscrew hyperlapse (720 degrees), but the resulting video was not very good. The object I was focused on was on and off center and the overall video was a choppy. There was no wind during the hyper lapse. Wondering if this is a Mavic Air 2 performance issue ?
https://support.dronelink.com/hc/en-us/articles/360052533153-Why-does-the-drone-fly-off-course-or-make-jerky-movements-during-certain-mission-plans-
The article makes sense.
Thanks
Please sign in to leave a comment.