Classic Flight Dashboard - Configure Network RTK for Legacy DJI Drones on iOS Only

  • Updated

For the Mavic 3 Enterprise (3E, 3T, SM) and M30 Series, see this article.

 

The below article is only relevant for legacy DJI (M series, P4PRTK) drones using a legacy Dronelink Classic Flight Dashboard. 

 

Configure the Network RTK directly in the Dronelink Mobile App on iOS Only. This is not supported on Android.

The Classic Flight Dashboard is required. Learn how to switch to the Classic Dashboard.

With the app open, connected to the RTK drone and mission plan opened, the Flight Dashboard shows the Network RTK button. By default it shows Disabled.

 

Step 1 - Select Network RTK Button to Begin Setup

mceclip0.png

 

Step 2 - Input Network RTK Settings and Select Confirm

Set Configuration settings to Enabled and Auto Connect.

mceclip2.png

 

Step 3 - Monitor Connection Status 

The Network RTK will display the status as Connected when successful. Open the Network RTK dialog to see the RTK Status.

 

mceclip5.png

mceclip6.png

mceclip7.png

 

 

 

Was this article helpful?

0 out of 0 found this helpful