Setup RTK connection in the Dronelink App Flight Dashboard, and monitor the RTK connection.
Toggle RTK on and off in the flight dashboard, setup Custom Network RTK and D-RTK2 Mobile Stations and monitor connection status. Learn how to setup RTK below.
Supported Drones: M3E and M30
Not Tested Drones / Beta: M300RTK
For legacy drones with RTK: P4PRTK, M210RTK - See this article to setup RTK
Step 1 - Open RTK Menu from Drone Settings Menu in Flight Dashboard
Step 2 - Select Custom RTK or D-RTK2 Mobile Station
Step 3 - Input Network RTK Service Details and Select Start Transferring
Input, NTRIP host, Port, username, password, and mountpoint details.
You must be connected to the network to establish a connection.
Step 4 - View RTK Connection Status and Flight Status
When the RTK connection is established and fully connected, all indicators will show green, along with the RTK under the satellite indicator.
If the RTK Positioning Status shows: Single Point or Float, the drone will not be able to take-off until Fixed Point is displayed, or RTK is disabled.
The drone flight status will update based on the RTK connection. If you cannot establish a good enough connection, then you should disable RTK.